
BATTERY TEST OR BATTERY START/STOP TEST
1. Prepare the test by selecting
the type of battery, the nominal voltage
and the defined capacity. (move your
finger towards the top to scroll through
the proposals)
3. The test report is
displayed.
2. Select «start test».
Confirm that the battery is charged.
4. Press «send test
results by email/mes-
sage» and select the
application.
Result
Screen display
Analysis
BATTERY OK
XX %
GOOD AND PASS
The battery is in working order.
OK FOR RECHARGE
XX %
GOOD & RECHARGE
Battery in good condition but low state of charge.
CHARGE & TEST
XX %
RECHARGE & RETEST
Charge the battery and perform the test again.
TO BE REPLACED
XX %
TO BE REPLACED
The battery is nearing the end of its life.
A replacement should be considered.
BATTERY DAMAGED, REPLACE
XX%.
DEFECTIVE BATTERY :
TO BE REPLACED
A problem at the cell level is observed (short cir-
cuit.....). Replace the battery.
SYSTEM TEST
1. In the menu select «Charging System»
2. Configure the test by selecting the battery type, nominal voltage and defined capacity (slide your finger up to scroll through the
proposals).
3. Select «start test». To return to the previous screen press «<» during the process.
4. Follow the instructions of the tester :
5. The test report is displayed. Press «send test results by email/message»
10
BTW 300
EN
Translation of the original instructions