VARIABLE SPEED ROTARY TOOL
5
■ Never stand on tool.
Serious injury could
occur if the tool is tipped or if the drill is
unintentionally contacted.
■ Never leave tool running unattended.
Turn power off. Don’t leave tool until it comes
to a complete stop.
■ Check damaged parts.
Before further
use of the tool, a guard or other part that is
damaged should be carefully checked to
determine that it will operate properly and
perform its intended function. Check for
alignment of moving parts, binding or moving
parts, breakage of parts, mounting and any
other conditions that may affect its operation.
A guard or other part that is damaged must be
properly repaired or replaced by an authorized
service center to avoid risk of personal injury.
■ Protect your hearing.
Wear hearing pro-
tection during extended periods of operation.
■ Keep tools dry, clean, and free from oil
and grease.
Always use a clean cloth when
cleaning. Never use brake fluids, gasoline,
petroleum-based products, or any solvents to
clean tool.
■ PROTECT YOUR LUNGS.
Wear a face or
dust mask if the operation is dusty.
■ Guard against electrical shock by
preventing body contact with grounded
surfaces.
For example: pipes, radiators,
ranges, and refrigerator enclosures.
■ Inspect tool cords and extension cords
periodically and, if damaged, have repaired by
a qualified service technician. Stay constantly
aware of cord location and keep it away from
the rotating wheel.
■ Never use in an explosive atmosphere.
Normal sparking of the motor could ignite
fumes.
■ Use only outdoor extension cords with
approved ground connection that are intended
for use outdoors and so marked.
■ Avoid awkward operations and hand
positions where a sudden slip could cause
your hand to move into the drill.
ALWAYS
make sure you have good balance.
■ Allow the motor to come up to full speed
before starting a cut to avoid binding or
stalling.
■ Do not use tool if switch does not turn it on
and off. Have defective switches replaced by
an authorized service center.
■ Replacement parts.
All repairs, whether
electrical or mechanical, should be made by
a qualified service technician at an authorized
service center.
■ Keep hands away from working area.
Do not hand hold pieces so small that your
fingers go under the tool. Do not reach
underneath work or in tool path with your hand
or fingers for any reason.
■ Before using the tool, be sure all
adjustments are secure.
■ Do not remove jammed cut-off pieces until
tool rotation has stopped.
■ Never start the tool when the accessory
is in contact with the work piece.
■ Never touch the rotating portion of the
tool or other moving parts during use.
DO NOT OPERATE THIS TOOL WHILE UNDER THE
INFLUENCE OF DRUGS, ALCOHOL OR ANY MEDICATION
THAT MAY IMPAIR YOUR JUDGMENT OR CONTROL!
When servicing use only identical Gyros® replacement parts. Use
of any other parts may create a hazard or cause product damage.
WARNING
WARNING
