Inflatable SUP Board | User Manual |
| Gymstick International | www.gymstick.com
7 / 9
8 / 9
MAINTENANCE
IMPLIED WARRANTY
The importer of this product assures that this device is manufactured with high quality materials.
The prerequisite for the implied warranty is the proper setup in accordance with the operating
instructions. Improper use and /or incorrect transportation and storage can void the warranty.
The implied warranty is valid for 1 year, beginning from the date of purchase. For eventual defects
please contact the dealer of this product within the guarantee period.
The warranty applies to all parts (as far as included in the scope of delivery).
The warranty does not cover:
• Damage caused by outer force or improper storage
• Misuse, abuse or neglect
• Normal wear and tear
• Exceeding the maximum weight capacity
• Incorrect handling of the product
• Non-compliance of the operating instructions
The device is intended for normal recreational activities.
Not intended for rental or any kind of professional usage.
Products marked with these symbols must be disposed of separately from your household waste, as they contain
valuable materials which can be recycled. Proper disposal protects the environment and human health.
Your local authority or retailer can provide more information on the matter.
IMPORTANT
•
Do not leave your SUP board under direct sunlight as it may cause over-inflation.
•
Clean your board always after using it to prevent damage from sand, salt water or prolonged
sun exposure. Use fresh water and mild soap when needed.
•
Drain the water from the paddle shaft after each usage.
•
Remember to check the air pressure before and after use, and deflate your board when needed.
•
Dry the board after each use, especially when storing to avoid mould damage.
•
Long-term storage is not suggested, because it may cause adhesive failure.
•
Regulardly check for any defects and repair if necessary.
•
Using air compressor is not allowed because it can easily over-inflate the board.
•
Always carry your board, as sharp debris may puncture it when dragging.
•
Store your board at room temperature between 0°C - 40°C, away from direct sunlight in a dry place.
1. Locate the puncture.
2. Use acetone to clean the area around the puncture.
3. Cut the patch to suitable size. Note that the patch needs to cover the puncture with approx.
25mm overlap on all sides.
4. Spread glue on the patch and board. Check that the glue is spread completely and evenly. Let the
glue dry for 5 minutes.
5. Place the patch on the puncture. Use firm pressure and a suitable metal or plastic plate to remove
any air bubbles.
6. Let the glue dry for 24 hours before inflating the board.
7. Check for any defects before using the board again.
If the valve is broken or leaky. Follow the below instruction on how to replace the valve.
REPLACING THE VALVE
The manufacturer Gymstick International Oy has no responsibility to any persons or entity for any loss,
damage sequence alleges to have happened directly or indirectly as a consequent of this product.
DISCLAIMER
MANUFACTURED FOR
HOW TO REPAIR
Gymstick International
Ratavartijankatu 11, 15170 Lahti
+358 10 229 3040
FINLAND
