Troubleshooting
Test the relay wiring to the magnet lock
Once you have finished the wiring, you should test if the wiring is correct and working by using a
paperclip. Do this before plugging the connector into the GateKeeper socket.
Find a paperclip, straighten it and then bend it as depicted below. Connect the paperclip into the
two holes where the two wires connect to the magnet lock. You should be able to see the door lock
activate or deactivate, depending on the type of lock.
To demonstrate, if the lock mechanism is unengaged (unlocked) before you connect in the
paperclip, it should be engaged (locked) after you connect the paperclip.
If the lock is engaged (locked) before you plug in the paperclip, it should become unengaged
(unlocked) after the paperclip is connected.
If that does not happen, it means that the wiring has not been done correctly on the lock
mechanism. Please check the power supply for the lock and other related wiring.
EPIC Sanctuary
78-106 Manchester St
Christchurch 8011
New Zealand
PO Box 13352
Armagh Mail Centre
Christchurch 8011
New Zealand
NZ (+64) 3 668 5727
AU (+61) 1800 849 001
US (415) 915 0375
Page 14