MOVEHEAD FIXTURE USER MANUAL
Page 8
1-255
0..1s-25.5s
1. PAN
0-255
Set up the data of each channel, and the contents and order of the
display are one-to-one correspondence with the channel list of
fixture.
……
0-255
……
0-255
N. Function
0-255
If the reset channel in the scene edits the effective reset data, the fixture will reset, but after reset,
the corresponding reset channel value will automatically set 0, preventing multiple consecutive
resets.
Looking at this page, you can get the current channel table slot of the fixture. For specific channel
data, please refer to the detailed channel description.
5.
Set light run parameter
Enter the page shown in Figure 6-5, adjust the field parameters of fixture, facilitate the installation
of fixture, etc.
ADVANCED SETTING
Pan Invert
Set the rotation direction of PAN
OFF
ON
Tilt Invert
Set the rotation direction of TILT
OFF
ON
P/T Rectify
Setting up fixture to detect XY lost step and correct
OFF
Uncorrected position after out of step
ON
After losing step, the position is automatically corrected and the out of
step fault is recorded.
Pan Offset
Setting the zero point of the PAN of the fixture
4-150
Tilt Offset
Setting the zero point of the TILT of the fixture
4-48
Data hold
When the fixture is not equipped with DMX signal, the output state of the fixture
OFF
No signal, so the motor and light source return to the position and state
when reset is completed.
ON
No signal, keep the last frame DMX data output.
Lamp mode
(lamp light source) Set the way to first open the lamp after power up
Power on
Turn on the lamp at power up and reset the lamp after 30 seconds.
After reset Reset the fixture after 3 seconds when power-on, and turn on the lamp
after reset.
Manual
After reset, manually turn on the lamp through the menu or console.
Reset
Reset fixture
Factory Setting
Pop up the confirmation box, select "SURE", and return the lamp parameters to the
factory settings.
When choosing power-on mode, the lamp will wait for 30 seconds after power-on, let the lamp
fully start, internal voltage is stable enough, then start the reset program, if the field capacity is
