GVision VW-CG Series, Руководство пользователя

Страница: 8 / 20

WWW.GVISION-USA.COM
20532 Crescent Bay Dr. #104, Lake Forest CA 92630 / Tel. 949-586-3338 / Fax. 949-272-4594 / Email. info@gvision-usa.com
8
Parameter Description
Time Zone Choose a time zone for your device.
System Time
Current system time of the device.
Click the
Set Time
text box and then set the time manually or select
Sync with
PC and then the device automatically synchronizes time with your computer.
Auto Update
Enable this function if you have a Network Time Protocol (NTP) server on the
network. The device synchronizes time with the NTP server at the set interval
when enabled.
The NTP server's IP address, port number, and update interval are required.
NTP Server Address
Enter the IP address of the NTP server.
Note:
Set only when automatic update is enabled.
NTP Port
Enter the port number of the NTP server.
Note:
Set only when automatic update is enabled.
Update Interval
The device time is updated every few minutes.
Note:

The valid range of input time is 1~10080 minutes.

Available when auto update is enabled.
2) Set the parameters. Some are described in the table below.
Note!
The device synchronizes time with the central server when operating in server mode.
3.3 Serial
Set the serial port on the device, including the number, serial mode, baud rate, date bit, stop bit
check bit and flow control method.
3.3.1 Serial Port Parameters
1) Click System > Serial > Serial Port Parameters .
2)
Configure the serial port. The figure below shows the RS485’s parameters.