GVA GVA15FLED, Инструкция по эксплуатации, Страница: 17 / 43

17
Powering the LED TV
To turn the power ON or OFF:
1. Make sure that you are aiming at the sensor from the TV.
2. Press the “STANDBY” button on the remote control
NOTE:
Make sure you are aiming at the sensor from the TV.
First Time Installation
17
Powering the LED TV
To turn the power ON or OFF:
NOTE: Make sure that you are aiming at the sensor from the TV.
You can select between the TV signal and the input signal of other
equipment connected to the TV.
Use this function to switch to the input source you wish to view.
Selecting an Input Source
Press SOURCE button on the remote control.
Press OK
1) Make sure that the power cable is properly plugged.
2) Press the “STANDBY” button on the remote control.
First Time Installation
When you switch on the TV f e, the First Time Installation menu
will be displayed on the screen.
- Use the buttons to select the language and then use the OK
- Use the buttons to select the power-saving mode and the “Default”
mode is power saving mode, press the button to exit.
- Use the
Press to move to desired input source.
buttons to select the country and then use OK
button to start searching for all the DTV/Radio programs in your area. This
may take a few minutes.
- When auto searching is complete, your TV will sho found.
Default
button to go to the next page.
When you switch on the TV for the first time, the First Time Installation menu
will be displayed on the screen.
- Use the
/
buttons to select the power-saving mode and the “Default” mode is power
saving mode, press the / button to exit.
- Use the
/ / /
buttons to select the language and then use the OK button to go to
the next page.
- Use the
/ / /
buttons to select the country and then use OK button to start
searching for all the DTV/Radio programs in your area. This may take a few minutes.
- When auto searching is complete, your TV will show the first channel found.
Selecting an Input Source
You can select between the TV signal and the input signal of other
equipment connected to the TV.
Use this function to switch to the input source you wish to view.
Press SOURCE button on the remote control.
Press
/
to move to desired input source.
Press OK button to select or confirm.