min 30cm
Introduction
Wall Installation
Guide to the Appliance
1. Screws B (x2)
2. Wall Mount
3. Wall Plugs
4. Pivot Arm
5. Wall Mount Cover
6. Screws A
7. Power Settings Indicator (0/1/2)
8. Pull Cord
9. Metal Hook
NOTE: Due to production improvements, the appliance may differ slightly from the diagram shown.
Diagrams in this instruction manual are for reference only.
• Before using your new heater, please carefully read through the following instructions.
Keep this booklet in a safe place so you can consult it later.
• After removing the packaging, make sure that the appliance is in good condition.
• The packaging materials may contain plastic, etc., which may be hazardous and therefore should not be
left within the reach of children.
IMPORTANT:
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or
similarly qualified person to avoid hazard.
Caring for the Environment
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection
facilities. Contact your local council for information regarding the collection systems available.
If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into
the groundwater and get into the food chain, damaging your health and well-being.
The Heater:
Must not be mounted less than 1.8m above the floor.
Must not be mounted less than 0.15m away from side wall(s) or any other obstructions.
Must not be connected or turned on before it is correctly mounted on the wall.
NOTE:
• Unpack carefully. Make sure to discard all packaging thoughtfully and to keep the mounting screw kit.
• The supplied accessories are designed for mounting on a brick wall. For other wall types, please consult
your local hardware store.
• Do NOT touch the heating elements; stains may be left which could then reduce the effectiveness / life of
the appliance.
1 Disassemble the Cover (5) from the Wall Mount (2) by removing the two screws.
2 Push the heater down to access the screw holes for wall mounting.
3 Hold the Wall Mount against the wall and mark positions. Drill holes and insert wall plugs (for a brick
wall). Use the provided screws to fix the heater to the wall.
4 Push the heater up to be parallel with the Wall Mount. Insert the metal hook on the back of the heater into
the Wall Mount to hold it in position.
5 Close the Cover and tighten using the two screws.
2
5
min 100cm
min 180cm
min 15cm
