HOW TO USE
BEFORE USE
• Remove shipping package, tape, etc, and leave doors open ventilate for a while.
• The unit is cleaned before shipment. However, clean the compartment interior after delivery.
• Please insert power supply plug into the wall outlet .single-phase to cat voltage.
• Allow the unit to operate for about 1 hour to cool the compartment before placing items in the cooler.
WAIT 5 MINUTES OR MORE BEFORE RE-STARTING
• Restarting the unit immediately after it has been turned off may cause fuses to blow and activate the circuit-
breaker, the compressor may be overloaded, and/or other damage may occur.
TEMPERATURE ADJUSTMENT
For showcase cooler, the interior temp, during fully loaded at factory default setting of position at 4-5
will be kept at 0-10°C. > If the ambient temp, is extremely high or the stuffing food inside is too much,
that might cause the interior temp, a little bit higher. So, it would be better turn the thermostat right so
as to maintence the right temp. On the opposite, if the ambinet temp, is very low or empty loaded, or
in less food storage, the interior temp, might be able to reach minus O°C, and in return to cause the
evaporator ice up; Thus, it would better switch the thermostat back to left so as to relieve something.
DRAIN TRAY
• Defrosting is performed automatically and drain water is collected in the drain tray.
• Water in the drain tray is evaporated automatically. In humidity.there is a large amount of water in the drain
tray, so please throw away drain water once a day.
EFFICIENT USE
• To prevent cold air from escaping, open and close the door quickly and keep the door opened for as short a
time as possible.
• Please install the unit in the place which is well-ventilated.
SHELF HEIGHT ADJUSTMENT
The shelf height can be adjusted.
Arrange the shelves in accordance with the dimensions of the items to be placed in the cooler.
