BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING
INSTRUCTIONS.
IMPORTANT SAFETY INSTRUCTIONS
WARNING
To reduce the risk of fire, electrical shock, or injury when using your appliance, follow these basic
precautions:
Read all instructions before using the APPLIANCE.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
• This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• WARNING: To avoid a hazard due to instability of the appliance, it must be fixed in accordance with
the instruction.
Save these instructions
INSTALLATION INSTRUCTIONS
• This appliance is designed to be free standing only, and should not be recessed or built-in.
• Place your unit on a floor that is strong enough to support the unit when it is fully loaded. To level
your unit, adjust the leveling legs at the bottom of the unit.
•
This appliance is NOT designed to be installed inside of a cabinet where the front is covered
by any type of door.
• Allow 10 cm of space between the top, back and sides of the unit, which allows the proper
air circulation to cool the compressor and condenser.
• Locate the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
Extreme cold ambient temperatures may also cause the unit not to perform properly.
• Avoid locating the unit in moist areas.
• Plug the unit into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized Avanti Products service center.
• After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before
placing food in the APPLIANCE compartment.
