19
Timer function
This function will work in any mode. The timer function allows you to set the length of
operation from 1 hour to 12 hours. Press the timer button
and the time indicator will
flicker. Press the + or – keys to increase or decrease the time. Once the timer has been
set, indicator ‘H’ will appear after 5 seconds and the timer will count down the hours in 1
hour increments, showing on the display the remaining operating time until the heater
will turn off. Pressing the + or – key once more after the display reflects 12 hours will reset
the heater to continuously running.
Thermostat instructions
1.
Press the
button until the display shows temperature indicator “SET °C”.
2.
To adjust “SET °C”, press the + button to increase the desired temperature and the -
button to decrease the desired temperature (from 5 to 35°C). Pressing the + key
once more after the display reflects 35°C will reset the heater to continuously
running and the display will show “- -“.
3.
Press the
button again to quit the temperature setting. The set temperature will
appear on the display.
Note
: It is normal for the heater to cycle on and off as it maintains the set temperature.
If you have set both the time and the temperature, they will each appear consecutively on the
display for 30 seconds.
Eco function
1.
This function will work in any mode. Press the ECO button and the display shows the
ECO indicator.
2.
When the air temperature drops less than 2 degrees below the set temperature, the
unit will come back on with 1500W power.
3.
When the air temperature drops more than 2 degrees below the set temperature,
the unit will come back on with 2500W power.
4.
When the air temperature reaches the set temperature, the heater will cut off.
SAFETY DEVICES
•
Your appliance is fitted with a safety device (tip-over switch situated on the bottom
of the appliance) that disconnects your appliance when it is tilted or tipped. If your
appliance falls, switch it off, replace it correctly and switch it on again.
•
This heater is also protected with an overheating protection that switches off the
appliance automatically in case of overheating, e.g. due to the total or partial
obstruction of the grids. In this case, unplug the appliance, wait about 15-20
minutes for it to cool and remove the object that is obstructing the grids. Then
switch it back on as described above. The appliance should operate normally.
Should the problem persist, please contact the nearest customer service.
Содержание HL82516we
Страница 44: ......
