Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
15
Assembly page 15/36
Fax +32 2 359 95 50
The heater should only be operated at a minimum distance of 50cm from any wall or other
object. Position the air flow in order to optimise the heating of the room. Avoid corners, small
volumes, floors and ceilings.
OPERATION
When the appliance is switched on for the first time, a slight smell may be emitted. Please
ensure sufficient ventilation. This smell will disappear very quickly.
Place the power selector in "0" position
and put the plug in a 230V power socket.
The selector allows you to choose the desired power. The higher the power, the faster the
heating will be.
The thermostat regulates the temperature in the room. If the thermostat is set at the maximum
level, the appliance works continuously.
When the selector is in
position, the appliance operates as a fan, but will not heat.
Power selector
0
OFF
Fan without heater
800W
1500W
Note: before switching off the appliance, we advise you to operate it in
position for 2 to 3
minutes in order to cool it down.
Swing function
This function will work in any mode. Pressing the swing button
will allow the heater to
oscillate left and right. To stop the oscillation, press the swing button once more.
SAFETY DEVICES
•
Your appliance is fitted with a safety device (tip-over switch situated on the bottom of the
appliance) that disconnects your appliance when it is tilted or tipped. If your appliance
falls, switch it off, replace it correctly and switch it on again.
•
This heater is also protected with an overheating protection that switches off the
appliance automatically in case of overheating, e.g. due to the total or partial obstruction
of the grids. In this case, unplug the appliance, wait about 15-20 minutes for it to cool and
remove the object that is obstructing the grids. Then switch it back on as described
above. The appliance should operate normally. Should the problem persist, please
contact the customer service.
CLEANING AND CARE
•
Before cleaning the appliance, ensure it is disconnected from the power supply and has
cooled down completely.
•
To avoid the risk of electric shock, do not clean the heater with water and do not immerse
it. Clean the housing with a damp cloth.
