5. Tighten locking screws CC).
6
.
Slide blade guides back into contact with blade and tighten
screws
(
B)
7 . Connect machine to the power source.
Vise Adjustment
To position the moveable vise jaw:
1 . Turn vise handwheel (A-Fig. 10) 1 /2 torn
counter-clockwise.
2. Move rack block CB-Fig. 10) to desired
location by sliding along the bed. Place
the rack block onto the rack.
3 . Turn the handwheel to tighten the vise.
To adjust the vise for angle cutting:
1 . Loosen bolts and move vise jaw (C
Fig. 10) to desired location.
Fig. 10
C
2 . Set the vise to desired angle, reinstall nuts and tighten the nut and bolt assemblies.
3 . Adjust the movable vise parallel to the fixed vise by loosening bolt (D-Fig • 10) adjusting
to parallel and tightening bolt.
Setting Up the Machine for Operation
1 . Select the proper speed and blade for the
type of material you are going to cut.
2 . Make sure blade tension is adjusted properly.
3 . Lift the saw frame up and turn off the oil
regulating micro switch.
4 . Place the stock between the vise jaws, set
the stock for the desired width of cut and
tighten the vise.
A C
Fig. 11
5
.
Make sure the left blade guide gracket
(A) is
adjusted
as close
as possible to the left vise
jaw(B) Fig. 11.
6. Turn the oil regulating micro switch (c)Fig. 11, counter-clockwise until the saw blade begins
to lower by the desired rate.
7 . Proceed to cut through the workpiece, as shown in Fig. 11. The machine will shut off upon
completion of cut.
11
