Guntermann & Drunck DVIMUX4-USB, Установка и эксплуатация

Страница: 7 / 36

Installation
G&D DVIMUX4-USB · 4
Connecting the console devices
Keyb.:
Plug the connection cable of the USB keyboard in this interface.
Mouse: Plug the connection cable of the USB mouse in this interface.
Line In: If desired, connect a microphone or a headset to this interface.
Speaker:
Connect the speakers to this interface for output of audio signals at the
active computer.
Monitor 1: Plug the monitor’s DVI-I cable to this interface.
USB 2.0 Devices: If you want USB devices to be available to the connected computers
(e.g. a printer or a mass storage device), connect these devices to the interfaces on
the front panel (see figure 1 on page 3).
ADVICE: Connect the cables of the console and the computers preferably block by
block and from the bottom up. By doing so, you will avoid already connected
cables blocking your view of the interfaces.
Figure 2: Interfaces to connect the console devices
IMPORTANT: You can also connect both input devices to the
USB2.0 Devices
interfaces
on the front panel of the device.
In this case, switching of the channels is not possible via keyboard!
NOTE: If you purchased a multi-channel variant of the KVM switch, connect the
additional monitors to the
Monitor 2
(MC2, MC3 and MC4),
Monitor 3
(MC3 and
MC4) resp.
Monitor 4
(MC4) interfaces.
Power
Monitor 1
Keyb./Mouse Speaker
CON
Line In Line In USB 2.0 Line Out
CPU 1
DVI-I CPU 1.1
Line In USB 2.0 Line Out
CPU 2
DVI-I CPU 2.1
Line In USB 2.0 Line Out
CPU 3
DVI-I CPU 3.1
Line In USB 2.0 Line Out
CPU 4
DVI-I CPU 4.1