Guntermann & Drunck DVI-Vision-Fiber-AR, Инструкция по установке и эксплуатации

Страница: 126 / 152

Configuration
47 · G&D DVI-Vision-Fiber
Changing the scancode set of PS/2 keyboards
If you press a key at the PS/2 keyboard, the keyboard processor sends a data packet
that is called scan code. The two common scancode sets (sets 2 and 3) contain differ-
ent scancodes.
In the default configuration, the KVM extender interprets any entry made at the
PS/2 keyboard with the scancode set 2.
Use the scancode set 3 if you cannot enter the pipe “|” or the arrow keys do not
work as expected.
How to change the setting of the scancode set:
OSD
1. Press Ctrl+Num (default) to open the on-screen display.
2. Select the row Console setup and press Enter if you want to adjust the scan-
code set of the remote console (at the CON module).
Select the row Local console setup and press Enter if you want to adjust the
scancode set of the local console (at the CPU module).
3. Under Scancode set press F8 to select one of the following options:
2  activates scancode set 2 for PS/2 keyboard inputs
3  activates scancode set 3 for PS/2 keyboard inputs
4. Press F2 to save your settings.
After you turn the KVM extender on again, the keyboard is initialised and the
selected scancode set is applied.
Config
Pa
n
el
1. Click on
KVM Extenders > [All Extenders]
on the directory tree.
2. Double-click the computer module of the KVM extender you want to con-
figure.
3. Click on the tab
Local
if you want to adjust the screensaver of the local con-
sole (at the
CPU
module).
Click on the tab
Remote > General
if you want to adjust the scancode set of
the remote console (at the
CON
module).
4. Under
Scancode set
select one of the following options:
Set 2
 activates scancode set 2 for PS/2 keyboard inputs
Set 3
 activates scancode set 3 for PS/2 keyboard inputs
5. Click
OK
to save your changes.
6. Turn the KVM extender off and on again.
After you turn the KVM extender on again, the keyboard is initialised and the
selected scancode set is applied.