2 - Wood Screws
2 - Star Washers
2 - Flat Washers
1 - Halogen Bulb
3 - Wirenuts
21 - Blade Screws
21 - Metal Washers
21 - Rubber Washers
Screw Package
To begin with, the site of installation must be clear of any obstructions. Walls, cabinet or cupboard
doors, and AC/heating vents (strong air currents will cause fan to wobble ) are common obstructions.
Also, you will need a securely mounted outlet box that is listed for fan support.
The only tools you will need are : A medium Phillips screwdriver, common sense, and a little caution.
Remove all parts from plastic bags, including the screw package.
B.
A.
A. Attach the blades to the blade arms using the blade screws, metal washers
and rubber washers, four of each per blade, as shown in Fig 1.
CANOPY
CANOPY
GLOBE
GLOBE
BALL &
DOWNROD
BALL &
DOWNROD
5 BLADE ARMS
5 BLADE ARMS
TOP SLEEVE
TOP SLEEVE
CLEVIS PIN
CLEVIS PIN
SAFETY CLIP
& WASHER
SAFETY CLIP
& WASHER
Remove all of the parts from the top styrofoam and remove the styrofoam. Use
this top piece to support the fan during preliminary assembly.
I.
Inventory the parts
II.
Preliminary Assembly.
5 BLADES
5 BLADES
FIG. 1
Take the ball & downrod and loosen the set
screw in the ball. Remove the pin and the ball
from the downrod. (If you have a longer
downrod, use it now.) See Fig. 2
Loosen the couplers set screws. Feed the
three wires from the top of the fan through the
downrod and insert the downrod into the
coupler. Align the holes in the downrod with
the holes in the coupler. Insert the clevis pin
through the coupler and the washer. Insert the
safety clip in to the hole in the clevis pin.
Tighten the set screws. See Fig. 3
Place the top sleeve, then the canopy around the
downrod. Slide the ball onto the downrod and
replace pin. See Fig. 4 Slide the top sleeve down
over the coupler.
Raise the ball so that the pin is in the slot and
tighten the set screw. See Fig. 5
B.
2.
1.
3.
4.
5. Make sure all of the screws are tight. At this time you may want to shorten the wires
from the fan to 6" from the ball. This helps when you tuck the wires into outlet box.
Fig. 5
Fig. 2
Ball Set Screw
Pin
Fig. 3
Fig. 4
Page 2
HANGING BRACKET
w/2 CANOPY SCREWS
HANGING BRACKET
w/2 CANOPY SCREWS
Gulf Coast Fans 2010 - Portions
â
1993