III.
Now to hang the fan...
Holding the fan carefully, lift it up to hanging bracket. Place the ball into cradle of the
bracket. Turn the entire motor assembly until it locks into place. The tab on the
bracket must be in the groove in the ball. Make sure the wires are not being pinched.
Fig. 5
This fan can be operated by a wall control or remote
control unit. The basic wiring instructions below are
for a wall control. Please refer to the instructions
provided with the wall control. For use with a remote
control refer to the wiring instructions provided with
the remote control. Keep in mind, the supply wire
colors may vary. (The wire colors in parentheses are
commonly found in existing structures.) Use the large
orange wirenuts to make the connections.
Please be sure power supply is off!
IV.
Wiring instructions.
V.
Final Assembly
1. Green ground wires to outlet box ground. (bare)
2. Black wire from fan to (black) wire from fan control.
3. Blue wire from fan to (red) wire from light control.
Now tuck the wires and wirenuts carefully into outlet box. Make sure wirenuts remain tightly on
connections.
Page 3
BLUE
FAN
BLK
WHT
FROM FAN CONTROL
FROM LIGHT CONTROL
SUPPLY NEUTRAL
SUPPLY HOT
FAN
LIGHT
GULF COAST
FIG. 6
FIG. 8
FIG. 10
FIG. 9a
FIG. 9b
Note the side of the blade you want to show. Now slide a blade
into one of the slots in the motor housing. The three holes
should line up easily. See Left side of Fig. 8
Now you must decide whether to use the
included halogen light or just the cover.
Using the 3/16"-32x3/8" blade screws, three of
each per blade, secure blade to motor. Repeat
this procedure with the rest of the blades. You will
have at least one screw left over; this is a spare. Be
sure all of the screws are tight. Right side of Fig. 8
Both Glass Dome and Cover Dome have a mounting
ring. Align the dimpled tabs of the plate with the gaps in
the fan's mounting plate, lift up into position and rotate
clockwise to secure. See Fig. 10.
A.
B.
C.
2.
1. a.
b.
2.
1.
If you will
not
be using the
halogen light fixture, the fixture
itself must be removed from
the fan. Remove the three screws
attaching it to the fan. Disconnect the
wires at the connectors by pulling firmly on
both sides. See Fig. 9a.
GAP
TAB
DO NOT
TOUCH
HALOGEN
BULB
If you
will
be using the halogen light, now is the
time to install the bulb. To install the 100W
halogen bulb, use the paper sleeve to install it
into the bracket. Press one end of the bulb into
one of the sockets until other end can be inserted
into other socket. See Fig. 9b. Halogen bulbs
must never be touched with bare skin. The oils
cause the bulb to crack and fail. If the bulb is
touched, clean it off thoroughly with isopropyl
achohol and a cotton swab or lint-free cloth.
Reinstall. Let it dry completely before lighting.
With the motor in place and the wires out of the way, slide the canopy up
to the hanging bracket. The canopy screw in the bracket will come
through the large end of the key slot in the canopy. Fig. 7. Turn the
canopy slightly, counter-clockwise, to hold in place, and insert remaining
canopy screw. Tighten the screws.
FIG. 7
CANOPY
Gulf Coast Fans 2010 - Portions
â
1993
