II
How to use
1. Function introduction of buttons and ports
1
Install battery
Power on:
Long press the function button until
the green light up, then release it to
turn on the gimbal.
Power off:
Long press the function button until
the red light always on, then release
it to turn off the gimbal.
If the battery power is too low,
the screen shall turn off automatically,
please long press the function button
for 3 seconds so as to make sure the
unit completely powers off.
Then you can recharge or replace
the battery.
Remove the hand
shank and insert one
22650 battery into it.
Single tap this button to switch
below Photo mode and
Video mode.
Long press this button to open
WiFi function, and long press
again to turn off WiFi function.
The default is Video mode.
The function button can
control power on or
power off.
2
Power on / off
!
Connect to a computer
with USB data cable so
as to read the video and
picture files in a SD card.
SD reading port
Connect with USB data cable by this
port to upgrade firmware or charge
the battery.
Please refer to “Firmware upgrade”
for the operation of firmware upgrade.
Please refer to “Charging mode” for
the charging mode.
USB port
How to use
Photo / Video
switchover button
Micro SD card *
(Equipped by users)
* Class10 high-speed micro
SD card is recommended
2
USB port
