Customer Helpline0333 3201989
11
Operating Instructions
8� MOUNTING PARALLEL GUIDE (SEE FIG H1, H2)
Slide the parallel guide arm through both parallel guide fixtures and tighten the locking
knob (a) to achieve the required cutting distance. The parallel guide can be mounted in two
positions as shown in H1and H2.
9� PENDULUM ACTION CONTROL (SEE FIG I)
The pendulum action varies the forward cutting angle of the blade for increased cutting
efficiency. This can also be adjusted during no load running. Refer to the chart 2 for more
details. Do not use excessive blade force when cutting with the pendulum action. The blade
cuts on the upward stroke only.
Chart 2
0
Thin materials. Fine cuts. Tight curves.
I
Hard materials, (e.g. steel & chipboard)
II
Thick materials ( e.g. wood ) & plastic
III
Fast cuts (e.g. softwood). Cutting in the direction of the wood grain.
10� BASE PLATE
Adjusting the angle of the base plate (7) enables bevel cutting. The base plate must always
be held firmly against the materials being cut to reduce saw vibration, blade jumping or
blade breakage.
a
a
9
H1
H2
I
