Customer Helpline
0333 3201989
8
Assembly Instructions
NOTE:
Before using the tool, read the instruction book carefully.
1� ASSEMBLY
Before use, the eye shields/spark arresters must be fitted to the grinder.
Remove both eye shields from packaging, position the shields over the two mounting
brackets above the grinding wheels with the flanges of the spark arrester facing away from
you, fix with the screw and washer provided. At this stage do not fully tighten. (SEE FIG A)
The next step is to adjust the eye shields/spark arresters. To do this move the eye shields/
spark arresters so as to obtain a gap as small as possible between the arrester and the
grinder wheel, not greater than 2mm, the screw must now be fully tightened, (SEE FIG B).
The gap must be maintained as the wheel wears.
2� WORK REST ADJUSTMENT
Take the work rest out of the package, fix on the grinder with the knob and washer provided
as shown in FIG C. The gap between the rests and the wheels should be checked before
use. Measure the gap between the grinding wheel and the rests; this should be as small
as possible not greater than 2 mm, if not, loosen the knobs on each of the rests, set the
correct gap and fully tighten. (SEE FIG D) The gap must be maintained as the wheel wears.
Max 2mm
Max 2mm
A
B
C
D
