Customer Helpline 0333 3201989
10
a
b
Operating Instructions
2. INSTALLING AND REMOVING THE BATTERY PACK (SEE FIG B)
a) TO REMOVE THE BATTERY PACK
Press the Battery Pack Release Button (8) firmly first and then slide the Battery Pack
out from your tool.
b) TO INSTALL THE BATTERY PACK
Slide the fully charged Battery Pack onto the tool with sufficient force until it clicks
into position.
3. ON / OFF SWITCH (SEE FIG C)
Press the On/Off switch (a) to start and release it to stop your drill.
The on/off switch (a) is fitted with a brake function which stops your chuck
immediately when you quickly release the switch.
It is also a variable speed switch that delivers higher speed and torque with increased
trigger pressure. Speed is controlled by the amount of switch trigger depression.
WARNING: Do not operate for long periods at low speed because excess heat
will be produced internally.
4. SWITCH LOCK (SEE FIG C)
The switch trigger can be locked in the OFF position. This helps to reduce the
possibility of accidental starting when not in use. To lock the switch trigger, place the
rotation control (b) in the center position.
5. REVERSIBLE (SEE FIG C)
For drilling and screw driving use forward rotation marked “
” (rotation control (b)
is moved to the left). Only use reverse rotation marked “
” (rotation control (b) is
moved to the right) to remove screws or release a jammed drill bit.
WARNING: Never change the direction of rotation when the chuck is rotating,
wait until it has stopped!
6. CHUCK ADJUSTMENT (SEE FIG. D)
To open the chuck jaws hold the rear section and rotate the front section of the chuck.
Insert the drill bit between the chuck jaws and rotate the front section in the opposite
direction. Ensure the drill bit is in the center of the chuck jaws. Finally, firmly rotate
B
C
