Customer Helpline 0333 3201989
12
Operating Instructions
9. BELT CLIP (SEE FIG F)
Screw the Belt Clip (7) on the tool with the screw provided in the plastic bag. The belt
clip (7) can be hooked on your belt or pocket, etc.
10. DRILLING
When drilling into a hard smooth surface, use a center punch to mark the desired hole
location. This will prevent the drill bit from slipping off center as the hole is started.
Hold the tool firmly and place the tip of the bit at the point to be drilled. Depress
the switch trigger to start the tool. Move the drill bit into the workpiece, applying
only enough pressure to keep the bit cutting. Do not force or apply side pressure to
elongate a hole.
If you want to activate the drill function (For drilling metal wood or plastic), turn the
torque adjustment ring on the drill position. If you want to activate the impact function
(For masonry or concrete), turn the torque adjustment ring on the hammer position.
Tungsten carbide drill bits should always be used for concrete and masonry.
When drilling in metal, only use HSS drill bits in good condition. Always use a
magnetic bit holder (not included) when using short screwdriver bits. When screw-
driving, apply a small quantity of liquid soap or similar to the screw threads to ease
insertion.
11. OVERLOAD PROTECTION
When overloaded, the motor comes to a stop. Relieve the load on the tool immediately
and release the on/off switch. Restart the tool as normal.
12. TEMPERATURE DEPENDENT OVERLOAD PROTECTION
When using as intended for the power tool cannot be subject to overload. When the
load is too high or the allowable battery temperature is too hot, the electronic control
switches off the power tool until the temperature is in the optimum temperature
range again.
13. PROTECTION AGAINST DEEP DISCHARGING
The LITHIUM-ION battery is protected against deep discharging by the “Discharging
Protection System”. When the battery is empty, the tool is switched off by means of a
protective circuit: The drill will no longer rotate. Remove the battery and recharge.
F
