GUDEL CP 3-5 V2, Руководство по эксплуатации

Страница: 180 / 350

Position the coupling on the motor shaft as follows:
Prerequisite:The transport securing device in effect at the gearbox is dis-
assembled
1 Clean the coupling and motor shaft to ensure that they are free of grease
2 If desired by the customer, mount the wedge on the motor shaft (wedge
on motor shaft not essentially necessary)
3 Apply corrosion protection agent to the motor shaft with a brush
4 Measure the distance Z
5 Push the coupling onto the motor shaft
(set L dimension according to table)
6 Position the coupling on the motor shaft:
6.1 Calculate dimension X and position coupling according to the cal-
culated dimension
6.2 Coupling rest a little on the motor shaft: Make use of X dimension
tolerance
7 Tighten the coupling screws:
7.1 Tighten alternately to 50% of the tightening torque TA
7.2 Tighten alternately with 100% of the tightening torque TA
The coupling is positioned.
Installing the mo-
tor and coupling
WARNING
Heavy components
Components can be very heavy. Improper handling can cause severe or fatal
injuries!
• Use appropriate lifting units
• Use suitable means to secure the components against tipping over
• Only remove the safety devices after the product has been completely as-
sembled
Vent the motor brake according to the specifications of the motor manufac-
turer
Maintenance OPERATING MANUAL CP 3-5 V2
9007202252815371_v1.0_
EN-US
180