Adjusting rodding for ejection opening
Put the eye bolt on the rodding (pic. 8-1).
Hook the rodding end on the pivot point and turn the
rodding to fix it to the post (pic. 8-2).
Secure the eye bolt on the bottom post with the wing nut
(pic. 9-1).
Wooden rod (pic. 10)
The wooden rod is primarily used to release the
accumulated and stuck ice remains in the eject tube.
Before removing the stuck material, the snow blower must
always be switched off and unplugged. Otherwise there is
a risk of amputation and getting jammed!
Before you start working
Check carefully the entire area you are going to work in
and remove all items such as mats, sledges, boards,
cables and other foreign items. Before starting the engine,
declutch the appliance and shift into neutral.
Wear appropriate winter clothes when working with the
appliance.
Wear shoes that adhere well to the slippery surface.
Use a grounded socket with three wires for all units with
electric driving engines or electric starters.
Set the working screw height so that it does not touch the
surface with rubble or road metal.
Never try to adjust the appliance when running (except
when it has been specifically recommended by the
manufacturer).
Let the engine and appliance adapt to the outside
temperature and then start removing snow.
There is a risk of items being thrown off at eyes when
working with power appliances.
Protective glasses or a shield should always be used when
operating, adjusting or repairing the appliance.
Operation
Switch-on and starting
To prevent unintentional appliance switch-on, the 2-point
safety switch is fitted with a safety pressure switch (pic.
11-A). This switch must be pressed before the switch lever
(pic. 11-B) is pressed. If the switch lever is released, the
safety pressure switch gets back to its starting position and
the engine stops immediately. Make sure the extension
cable is not within rake's reach and is properly connected
with the switch (pic. 5, 11).
Marking
Product safety:
Product corresponds to
appropriate EU standards
Protection class II
Prohibitions:
No pulling the cable!
Protect against rain and
moisture!
Using indoor prohibited
Do not touch inside the
appliance
Make sure the processed
material does not contain
any metal items, stones,
bottles, cans or other foreign
items.
Warning:
Warning/caution
Warning against dangerous
voltage
Warning against thrown-off
items
Warning! Rotating
appliance poses a risk of
injury!
Caution, risk of drawing-in
Keep bystanders in safe
distance from the appliance
(at least 5m)
Risk due to rotating knife of
the blower. Never put hands
and legs in the hole.
Warning against thrown-off
items
Never aim the eject tube at
living creatures, cars and
buildings.
Commands:
General command mark
Read carefully the
Operating Instructions.
Familiarise thoroughly with
the appliance use
principles.
Use protective glasses
Use protective gloves
Use safety shoes
Environment protection:
Dispose waste professionally
so as not to harm the
environment.
Packing cardboard material
may be delivered to
collecting centres for
recycling.
16
