ASSEMBLY / PREPARATION
All assembly and/or maintenance works may be
performed only when the motor is turned off!
Please read the entire operating instructions before
assembling or starting your new mower.
IMPORTANT
: The mower is supplied without oil and
petrol.
UNPACK THE MOWER
Take the mower out of the board and check whether there
are any free parts left there.
Assembly of collecting bag
Take the collecting bag out of the package and fix it to the
associated framework like you can see in the picture below.
Assembly - Handle
IMPORTANT:
Disassemble the handle with care to prevent
clamping or damage of the cables.
1.
Lift the handle until it snaps in the working
position.
2.
Remove the protection sleeve, lift the upper parts of the
handle and assemble it with the bottom part. Tighten
the safety bolts on both sides of the handle.
3.
Remove the protection sleeve of the operation grab handle in
the upper part.
Operation
Operation lever (for automatic stopping) (12)
– press
the lever towards the handle when starting. If you want to
switch the engine off release the lever.
Drive lever (13) -
used when you want the mower to be
moving forward.
Use
Cutting and Mulching
When the mulching wedge is inserted (see the picture and
“Changeover to mulching“ article) the grass is not thrown up
but ground by the cutting knives and the grass will remain as
surface fertilisation on the lawn (Side ejection must be closed)
Cutting and collecting
The grass is collected to the grass catcher (if the grass is
damp or wet it reduces the catcher capacity). If you want to
mount the catcher to the mower lift the cover plate and hang
the grass catcher.
Cutting (without grass catcher)
The cut grass is laid in strips.
Cutting (side ejection)
Hewed long grass lies down in the strips.
Lift the side flap and mount the hooks of the
side ejection
into the axis of the side flap. Then release the side flap down
and make sure that the
side ejection
is well secured.
Changeover to mulching
Assembly and disassembly
of accessories must always
take place when the engine is switched off.
Remove the grass catcher, insert the mulching wedge to the
ejection channel and lock the mulching wedge
(1)
ensuring it
with a self-securing hook
(3)
.
Please make sure the mulching wedge is mounted firmly after
the changeover.
Attention!!!
Use original equipment from the producer only.
Disassembly
Press with thumb in the middle
(3)
then release and pull the
mulching wedge out.
Attention!!!
If the mower is blocked during mulching reduce the
travelling speed so that the knife could continue in
grinding the grass and spread it on the lawn. Never
remove the gathered grass with your hands.
DRIVE CONTROL
The self-propelling travel is controlled as follows: Press the
operation lever (lever for automatic stopping)
(12)
towards the
handle and simultaneously press the drive lever towards the
handle
(13)
.
disengage
Press up
14
Содержание 06010
Страница 2: ...1 2 3 3 4 5 6 7 8 9 10 11 12 13 14 ...
