GUARDO SWIFT 200, Руководство пользователя

Страница: 8 / 28

-8-
CARE & MAINTENANCE
WARNING! As with any mechanical component, a vehicle is subject to high stresses and wear. The
various materials and components may react differently to wear or fatigue. If the expected service
life for a component has been exceeded, it may break suddenly, therefore risking causing injuries to
the user. Cracks, scratches and discoloration in the areas subject to the high stresses indicate that the
component has exceeded its service life and should be replaced.
Your E-Scooter Swift 200 will require regular maintenance. Please use following checklist to ensure
your E-Scooter runs smoothly for a longer time.
• Charge your battery often. Avoid charging your battery for too long to avoid damage to it.
• Always allow your battery to cool before charging to help increase your battery’s life expectancy.
• Avoid riding in wet conditions when possible, to avoid excessive exposure and corrosion.
• Keep all moving components clean. Once a week, use a clean, damp cloth to wipe off dust and
grime that collected on the handlebars and stem. Wash the deck with lukewarm water and a bit
of dish soap. Take care not to get the electrical components wet. Let the components dry before
you use the scooter again.
• Check your brakes and rotors for wear and tear on a weekly basis. Do not ride your E-Scooter if
the brakes don’t respond properly.
• Inspect all cables for wear and tear regularly. If you notice any damage to the cables or their
housing, they may need to be replaced.
• The self-tightening nuts, as well as the other self-tightening fastenings, may lose their efficiency.
They may need to be retightened as follows: M4 bolt: 2.5~3.5 N/m - M5 bolt: 4~6 N/m - M6 bolt:
12~14 N/m - M7 bolt: 27~29 N/m.
• If you’re using your E-Scooter as your primary means of transportation, it is advised to contact
your reseller and schedule an annual inspection with a qualified maintenance shop.
• Keep all joints and parts lubricated. Please lubricate at least once a month to keep the scooter
in good condition. Please use lubricants designed for bicycles and scooters.
• Store your E-Scooter in a safe place (inside) to prevent damage to electrical parts or the battery.
Choose a location that’s out of direct sunlight and in an area where temperatures are steady.
Cleaning
If stains appear on the surface of your scooter, rub them with a soft and damp cloth. In case of
stubborn stains, you can first scrub with a soft cloth soaked in toothpaste, then rub with a soft, damp
cloth. Never clean with alcohol, gasoline or other corrosive or volatile chemical solvents. This may
damage the appearance and structure of the vehicle. Never use a pressure washer to clean your
scooter, you may be subjected to electric shock or cause serious damage to your vehicle.
Storage
You must store your vehicle in a room away from heat and moisture. Prolonged exposure to the sun
or heat can accelerate the aging of your scooter and shorten battery life.
Battery maintenance
Please do not expose the batteries to an environment higher than 50°C or lower than - 20°C (e.g. do
not leave the battery in the trunk of your car), this could cause ignition of the batteries or significant
damage to your drums. To prevent the battery from being discharged, try recharging it regularly and
not waiting for it to discharge completely. To make the best use of battery life, it is recommended
to use it at normal temperatures. When the battery is full, charging is available up to 90-120 days
in pause mode. If the battery is not full, charging is available up to 20-50 days in pause mode. It is
important not to leave the discharged battery for too long as this could cause serious damage.