DIRECTIONS FOR USE
7. Use the temperature buttons (+/-) to select
either low or high temperature depending
on your preference.
NOTE: You will notice a difference in
the sound of the fan on low and high
temperatures, this is normal.
8. Use Steam Inhaler by placing mask over your nose and
mouth lightly. Pinch the metal tab for a secure fit. Use inhaler
in upright position only.
NOTE: During use, the device will cycle and you may
feel a momentary cooler temperature steam, this is
part of the cycle and normal.
E-6
9. Take slow, deep breaths through your nose, for at
least 2-5 minutes. Repeat as necessary until cycle
completes. It is not recommended to use the inhaler
longer than 20 minutes in one sitting. However, you
can repeat the steam inhalatoin 2-3 times per
day as symptoms persist.
10. Steam Inhaler will run a drying cycle and then
turn off automatically when out of water
(a red "Empty" light appears). For longer use, refill the reservoir and turn the device on.
The power light will turn green. If the Green Error light is blinking make sure you are using
the correct water. Replace water with distilled water only.
IMPORTANT: Please note that using any additives in the water tank, any other liquid or
water with minerals (e.g. bottled, purified, or boiled water) will damage the device and
will void the warranty.
11. Automatic Drying Cycle: Each time after the device is turned OFF, a fan will run for 10 minutes
to dry internal parts of the device. It stops automatically when complete.
IMPORTANT: Do not interrupt, refill reservoir, unplug or turn off the device when the
fan is running the drying cycle.
12. If you have water remaining in the water tank AFTER the drying cycle is complete,
you can empty the remaining water.
TROUBLE SHOOTING GUIDE
Red “Empty” light indicator.
A red light means the unit is out of water or the water level is
too low. Refill the water tank.
PROBLEM
SOLUTION
Fan noise when orange
light is on.
Troubleshooting your device, please make sure that you have distilled water in the device.
If you hear the fan during a orange light, the drying cycle
is on. Leave it until it stops by itself or start another session.
Green blinking Error light.
You are using water that is not distilled. Please replace water
with distilled water. You may have to do this repeatedly until
the light stops blinking.
Inhaler may be tipped over too far. Hold upright while using.
E-7
Steam gets cool while using. This is normal and part of the water heating cycle.
Inhaler won’t start or stops
working.
Check water level and add more distilled water if needed.
Check that plug is inserted into both the unit and the wall outlet.
6. Press the ON/OFF button to allow the water
to warm up. This will take approximately
1-2 minutes. You can start and stop the device
as much as you want - just make sure you let
it run the drying cycle once finished.
Steam feels too hot.
Check that unit is set to low setting.
Take breaks, as needed, while using the inhaler.
Inhaler has an odor.
Before first use or after unit has been stored, rinse water
tank and run inhaler through a complete cycle before using.
