Guardian Telecom P6300, Руководство по установке и эксплуатации

Страница: 15 / 24

Guardian Telecom Inc. Installation and Operation
WRR/WRT-VoIP Series Telephones
13.5. RESET Switch
When the Telephone is operational and linked to the network use the Reset Test Function Management
(RESET)
switch (Figure 9), on the Telephone board to announce, the Telephone’s IP Address, and test that the
audio is working (see Section 8.5.1). The message will come through the handset receiver.
Figure 9 - RESET Switch
14. Announcing the IP Address
To announce a telephone’s current IP address:
1. Press and release the RESET switch (SW1). Do not hold more than five seconds.
Note:
The telephone will use DHCP to obtain the new IP address (DHCP-assigned address or default to 10.10.10.10
if a DHCP server is not present).
Note:
Pressing and holding the RESET switch for longer than five seconds will restore the telephone to the factory
default settings.
15. Restore the Factory Default Settings
When troubleshooting configuration problems, it is sometimes convenient to restore the device to a known state.
Note:
Each Telephone is delivered with factory set default values.
To set the factory default settings:
1. Press and hold the
RESET
switch (SW1) for more than five seconds.
2. The telephone announces that it is restoring the factory default settings.
Note:
The telephone will use DHCP to obtain the new IP address (DHCP-assigned address or default to 10.10.10.10
if a DHCP server is not present).
16. Adjust the Volume
You can adjust the volume through the Device Configuration Page.
Page 15