background image

   

G

ua

rd

ia

Fa

ll 

Pr

ot

ec

tio

  6

30

S.

 2

31

st

 S

t.

, K

en

t,

 W

A

 9

80

32

   

   

 p

ho

ne

: (

80

0)

 4

66

-6

38

 f

ax

: (

80

0)

 6

70

-7

89

   

  w

w

w

.g

ua

rd

ia

nf

al

l.c

om

5

Quick Connect Buckles are activated by engaging two release levers simultaneously to
release the male piece from the female receiver. Adjustments are made by feeding
webbing through the male end using a friction style buckle.

Dorsal D-ring, chest strap, shoulder straps, and leg straps

MUST be fitted for each individual user.

Maintenance, Cleaning, and Storage

If an Edge Harness fails inspection in any way, immediately remove it from service, and contact Guardian to
inquire about its return or repair.

Cleaning after use is important for maintaining the safety and longevity of Edge Harness. Remove all dirt,
corrosives, and contaminants from Edge Harness before and after each use. If an Edge Harness cannot be
cleaned with plain water, use mild soap and water, then rinse and wipe dry. NEVER clean Edge Harness
with corrosive substances.

When not in use, store equipment where it will not be affected by heat, light, excessive moisture, chemicals,
or other degrading elements.

1. Hold at dorsal D-ring, and
fully inspect harness according
to specifications of this instruction
manual. Ensure all straps are not
twisted and all buckles are
unfastened. 

2. Place harness shoulder straps
over shoulders. Ensure dorsal
D-ring faces out, and is adjusted
to rest between the middle of
the shoulder blades.

3. Connect leg straps around thighs.
Ensure there is no twisting of
webbing. Leg straps should never
dangle or hang loose.

4. Adjust chest strap height to
lower chest level, approximately
6” from top of shoulders. Connect
chest strap. Ensure there is no
twisting of webbing.

5. Adjust chest, leg, and
shoulder straps so they fit
snugly, but still allow for a
full range of movement.

Some steps of donning a harness may require assistance from another person.  Upon completely
donning a harness, Guardian Fall Protection recommends that another person, with knowledge of the
safe and correct use of the harness, inspect to ensure the harness is being worn correctly.

Any twisting of webbing, or

straps that are fitted too loose

or too tight, can significantly

increase the risk of serious

injury or death in the

event of a fall.

!

WARNING

Содержание Edge Harness Series













Отзывы: