Guardian Fall Protection 15026, Инструкция по эксплуатации

Страница: 14 / 16

G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
tio
n
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
12
Installation:
1. Loosen Clamp Bolts so Friction Fit Bracket will fit over selected 2” x 4” fascia board. Friction
Fit Bracket must be installed from bottom of fascia board. Clamp Bolts must face away from
work area.
2. Place Friction Fit Bracket onto selected fascia board, and ensure that, when closed, Clamp
Plates will lie completely flush against fascia board.
3. Tighten both Clamp Bolts to 30 foot-pounds. Use a correctly calibrated torque wrench to
ensure both Clamp Bolts are torqued properly.
4. Repeat steps 1-3 for all Friction Fit Brackets at all selected installation locations.
5. Install all required guardrail posts into Friction Fit Bracket Guardrail Post Installation Locations.
Guardrail post rungs must face in towards work surface.
Work Surface
Guardrail rungs
face in towards
work surface.
Clamp Bolts
face away from
work surface.
6. Install all guardrails. Guardrails may be compatible snap-on metal rails, or 2” x 4” or
2“ x 6” construction grade lumber. If using lumber guardrails, guardrails MUST overlap a
minimum of 12” at each end between consecutive guardrail posts.
Clamp Plates flush
against fascia board.
Clamp Bolts
torqued to 30
foot-pounds.
Guardrail post
fully inserted into
Guardrail Post
Installation Location.
Minimum 12”
guardrail overlap
(for lumber guardrails).