PARTS, DISASSEMBLY AND RE-ASSEMBLY
13
A
B
C
D
E
G
F
Parts List
A
Handle Assembly
B
Gauge
C
Gauge Seal
D
Valve Cap
E
Spring
F
Valve Seal
G
Valve Stem
TOOLS NEEDED
• 1/2” square drive
• PTFE thread sealant tape
• Pick or flathead screwdriver
• 15/16”, 6-point socket
REPLACING PRESSURE GAUGE
Step 1: Remove gauge seal with pick or small flathead screwdriver.
Step 2: Remove pressure gauge with 15/16” socket and discard.
Step 3: Apply thread sealant tape to threads of new pressure gauge – do not
block air inlet of the pressure gauge.
Step 4: Thread new pressure gauge into handle and tighten with 15/16”
socket. Do not over tighten.
Step 5: Insert new gauge seal.
REPLACING VALVE COMPONENTS
Step 1: Remove valve cap with 1/2” square drive.
Step 2: Remove and discard the spring, valve seal, and valve stem.
Step 3: Clean and inspect valve stem and bronze bushing.
Step 4: Apply lubrication (included) to the new valve stem and insert into the
handle.
Step 5: Insert the new seal with the black seal face facing downwards.
Step 6: Insert the new spring.
Step 7: Apply thread sealant tape to the threads of the existing valve cap.
Step 8: Use 1/2” square drive to thread valve cap into the handle. Firmly tighten.
INSTRUCTIONS
