GTR SPRINTCAR BLEEDERS Скачать руководство пользователя страница 1

Страница: 1 / 4

BATTERIES

1 x 9 volt battery is required in each unit,

these can be either conventional throw

away batteries or rechargeable. Battery

voltage is displayed on main screen

however due to the option of conventional

or throwaway batteries the voltage differs

between the two. Therefore, this will need

to be monitored between different types

of batteries to get an accurate reading.

To install battery:

- Remove battery-retaining cap (shown

in figure 1) using 3/32 allen key.

- Install battery into housing

(figure 2a & 2b).

- Re-fit battery-retaining cap ensuring

cap screws are firmly tightened.

Figure 1.

Figure 2a.

Figure 2b.

WWW.GTRDEVELOPMENTS.COM

GTR SPRINTCAR BLEEDERS MANUAL

Содержание SPRINTCAR BLEEDERS

Страница 1: ...ries the voltage differs between the two Therefore this will need to be monitored between different types of batteries to get an accurate reading To install battery Remove battery retaining cap shown...

Страница 2: ...ing desired Tyre pressure Scroll down to PRESSURE figure 4 press to the right this will allow setting of pressure by pushing up or down to the desired setting Then by pressing right this will set the...

Страница 3: ...other until the lock starts to tighten in axle When bleed unit is inserted into lock but not rotated into the locked position push bleed unit into axle until the spacer ring on the bleed unit is fully...

Страница 4: ...afety equipment or manufactured goods collectively goods GTR Developments Ltd assumes no responsibility for any damage to other goods or bodily injury that may arise due to failure of other goods due...