
rev - 12/01/10
©2010 Gates That Open, LLC
Printed in China for GTO
Estate Intercom/Keypad Features
Keypad
•
The keypad illuminates
and
beeps at
the
press of
any
key.
At
night, the
keypad will
illuminate
when the
proximity
sensors detect motion near
the
keypad
face.
•
When a
valid
code
is
entered, the
STATUS light
will
blink
rapidly, the
keypad will
beep
three times, and
the
GRANTED
light
turns green.
•
The keypad remains active for
40
seconds after
entering a
valid
code: pressing any
key
on
the
keypad while the
gate
is
in
motion will
stop
the
gate;
pressing
any
key
while the
gate
is
stopped will
cause the
gate
to
reverse
direction.
After
40
seconds, the
keypad will
beep
3
three times and
go
into
“idle” mode, and
the
GRANTED
light
will
turn
off.
•
If
more than
20
key
presses are
entered without matching
an
Entry Code, the
STATUS light
will
flash
rapidly, an
error
tone
will
sound for
1
second, and
the
keypad will
go
into
“lock-down”
mode for
40
seconds.
•
If
more than
10
seconds elapse between key
presses, the
keypad will
beep
3
three
times and
go
into
“idle” mode.
Master and Entry Codes
•
Up to
100
Entry Codes may
be
programmed
into
the
keypad.
•
Temporary
Entry Codes can
be
programmed
to
expire within one
to
seven (1–7)
days.
•
Entry Codes remain stored in
memory even
when the
keypad batteries
go
dead.
•
All
Entry Codes are
deleted by
pressing the
RESET button on
the
keypad; Master Code
defaults to
“1234.”
Base Unit
•
The base
unit
is
powered
by
a
rechargeable
battery (included);
the
charge
is
maintained
by
the
transformer.
•
The base
unit
can
be
disconnected
from
the
transformer
allowing it
to
be
moved anywhere
within range.
•
Up to
three additional
base
units
can
be
added to
the
system.
NOTE: The keypad, not the base station, initiates the call and operates the gate. The base station is for answering calls and
granting “permission” for the gate to be opened.
INTERCOM/KEYPAD SPECIFICATIONS
Frequency
318 MHz from keypad to gate opener
900 MHz from keypad to base station
Memory – Keypad
Stores up to 100 four-digit entry codes
Power Consumption – Keypad
60 mA when relay is closed
Power Supply – Keypad
Four C batteries (plus 8-24 Vdc for hard-wired installations)
Power Supply – Base Unit
9 Vdc 300 mA transformer; 3.6V Ni-MH 800 mA rechargeable battery pack
Range from Keypad to Base Unit
500’ wireless
Range from Reypad to Gate Opener
50’ wireless 100’ wired using 16 AWG wire
Relay Output – Keypad
Momentary, normally open dry contact closes for 2 seconds upon activation
Relay Output Rating – Keypad
12 or 24 Vdc 100 mA
Wiring – Keypad Power & Relay Output
16 AWG stranded low voltage direct burial wire
Содержание F3101MBC
Страница 8: ...rev 12 01 10 4...