Care &
Maintenance
WARNING:
Do not accidentally turn the
unit on while cleaning it.
Each week clean the product with a dry
cloth, plus the chamber in which the Dust
Tray fits. Remove hair and fibre from the
Brush Bar and Edge Wheel.
1
Don’t use abrasive materials to clean
the product or immerse it in water.
2
Don’t pick up liquids or use on wet floors.
3
Don’t use on concrete, Tarmacadam
or other rough surfaces.
4
Don’t pick up pieces of string or fabrics
with the unit.
5
Don’t clean rug tassels or frayed
carpets with the unit.
Brush Bar & Edge
Wheel Removal
The Brush Bar and Edge Wheel can be
removed for cleaning or replacement.
1
Push the latch and un-hook the
Edge Wheel Cover from the front of
the
unit.
2
Slide the belt off the end of the Brush
Bar drive gear.
3
Lift the end of the Brush Bar, then
slide out of the unit.
4
The Edge Wheel Brush can be pushed
out of the cover.
5
Remove any hair, fibre and dust from the
Edge Wheel and Brush Bar.
6
Replace the Brush Bar by fitting the shaft
into the bearing in the housing, then
engage the end with the drive gear into the
unit.
Note: peg to relocate
into
unit.
Note: peg
to relocate
into unit.
4
Product Is Not Working Properly?
1
Empty the Dust Tray.
2
Remove any build-up of hair or fibre from
the Brush Bar and Edge Wheel.
3
Fully discharge the product (run until
battery is flat) and then recharge for
16 hours.
.
7
Refit the belt onto the drive gear.
8
Hook the Edge Wheel Cover back onto
the unit and push into place until the
latch is securely engaged.
Battery Pack Removal & Replacement
Follow these steps for battery removal
or replacement:
1
Switch off the product and ensure
the Charger is disconnected.
2
Remove the Telescopic Tubes and
Dust
Tray.
3
Turn the unit over, being careful not
to switch the product on.
4
Press the clip to release the
Battery
Cover.
5
Carefully lift the battery out.
6
Slide the plastic cover off the black (-)
cable
connector.
7
Push the latch on the connector and
pull the connector off the battery
contact.
8
Repeat for the red (+) cable connector.
9
Push the cable connectors onto the
new battery contacts, ensuring they
are securely fitted.
10
Slide the plastic covers back over the
connectors.
11
Replace the battery into the
compartment and refit the battery cover.
WARNING:
NEVER touch both the metal
battery contacts at the same time with any
metal objects as this may create sparks
that can cause small burns.
NEVER use the unit in a partially assembled
state.
5
ONLY USE A REPLACEMENT BATTERY AS SUPPLIED BY MANUFACTURER
Replacement batteries, Brush Bars and Edge Wheels can be purchased
through the helpline Tel: 01905 345891 or by visting www.gtechonline.co.uk
At the end of the product’s or battery’s life
the battery should be removed for disposal
and recycling. Only a technically competent
person should undertake battery removal
and replacement.
If uncertain as to how to replace your battery
pack, we suggest you take your unit to a reputable
small appliance service technician to have this
service performed.
Underside of Sweeper
Battery Connector
Battery Cover
Clip
Cable
Connector
