10
Attaching the belt clip
The belt clip (H) may be installed on either side
of the tool.
To install, insert the clip into the groove in the
housing and fasten it with screw.
To remove, simple remove the screw and then
remove the belt clip (H).
The state of charge of the battery can be
tested by pressing the button. Three bars
indicates a full charge, two bars a partial
charge, one bar low charge.
WARNING:
Allow battery to cool down before
charging if the battery is hot after
continuous use.
BATTERY
All batteries wear out over time due to normal
wear and tear. Do not attempt to disassemble
and repair the battery, as this could cause
serious burns especially when wearing rings
and jewellery. For the longest possible battery
life, we suggest the following:
• Remove the battery from the charger once
fully charged.
• Store the battery away from moisture and at
a temperature below 80°F.
• Store the battery with at least a 30% 50%
charge.
• If a battery has been stored for six months or
more, charge the battery as normal.
Battery state of charge indicator
4615_Impact_driver_manual_aw.indd 10
4615_Impact_driver_manual_aw.indd 10
28/10/2020 16:38
28/10/2020 16:38
