30308778 Issue 1.06
Z2
Z1
GND
+24V
S-
Z1
D1
D2
S+
Z2
I-9301
4.7kΩ
1
Z
D
1
S
2
Z
K
2
D
2
1
K
G
Fig. 3
The module connects with filed devices as
shown in Fig. 4. The working mode is two-wire.
Control Input
Z2
Z1
Controlled Devices
COM
Z1
NO
Z2
I-9301
NC
Fig. 4
Setting Working Modes
On power on state, press
Function
and number “3”on
the programmer
, “_” will show on the last digit.
Inputting one working mode and pressing
Program
, it
will display
“P” on the screen. The working mode has
been set. Factory default mode is two-wire (number
“2”). Four-wire mode (number “1”) can be
programmed in field. Program the module before
installation and select the working mode according to
actual situation.
Warning:
Please do not connect the contact to AC control
loop directly to avoid the module or controlled
devices
being
damaged
by
strong
AC
interference.
WEEE Information
2012/19/EU
(WEEE
directive):
Products marked with this symbol
cannot be
disposed
of as unsorted
municipal waste in the European Union.
For proper recycling, return this product to your local
supplier upon the purchase of equivalent new
equipment, or dispose of it at designated collection
points.
Specification
Operating Voltage
Signal Loop 24V(16V
～
28V)
Power 24VDC(20VDC
～
28VDC)
Standby Current
Loop
≤
1mA ; Power
≤
5mA
Action Current
Loop
≤
3mA ; Power
≤
20mA
Output Capacity
Four-wire mode: 24VDC/1A
Two-wire mode: 24VDC/2A
Output Control Type Four-wire mode: Volt contact
output
Two-wire mode: Relay normally
open normally closed volt-free
contact output
Programming
Method
Electronically addressed
Code Range
One address within 1~242.
Indicators
Active Indicator: Red, flashes
when polling. Illuminates in
action.
Fault
Indicator:
Yellow,
illuminates in fault.
Ingress
Protection
Rating
IP30
Operating
Temperature
-10
℃
～
+55
℃
Relative Humidity
≤
93%, non condensing
Material
of
Enclosure
ABS
Dimension
(L
×
W
×
H)
120mm
×
80mm
×
43mm
(with base)
Weight
About 194g (with base)
Accessories and Tools
Limited Warranty
GST
warrants that the product will be free of charge
for repairing or replacing from defects in design,
materials and workmanship during the warranty period.
This warranty shall not apply to any product that is
found to have been improperly installed or used in any
way not in accordance with the instructions supplied
with the product. Anybody, including the agents,
distributors or employees, is not in the position to
amend the contents of this warranty. Please contact
your local distributor for products not covered by this
warranty.
Model
Name
Remark
P-9910B
Hand Held
Programmer
Order separately
B-9310
Back Box
Order separately
This Data Sheet is subject to change without notice. Please contact GST for more information or questions.
Gulf Security Technology Co., Ltd.
No. 80, Changjiang East Road, QETDZ, Qinhuangdao, Hebei, P. R. China 066004
Tel: +86 (0) 335 8502434 Fax: +86 (0) 335 8502532
www.gst.com.cn
