
- 36 -
HDE 400
iP
outPut
signal
Herein you get access to the submenus for IP output settings.
—> If no IP output settings should be done, press button
.
The "ASI output" – "
OUTPUT ASI
" main menu is activated (page 42).
Bx 2
IP
OUTPUT
=>
• Press button .
—> The "Setting the output data rate" – "
DATARATE
" menu is activated.
s
et ting
the
outPut
data
r ate
In this menu you can set the output data rate of each IP output optionally to
automatic (auto) or to a fixed value.
IP 1
( 7.3)
>
DATARATE
!
10.0 MB
—> Dependent on the network, the sum of the output data rates of all
IP outputs must not exceed 80 Mbps (100-BASE-T interface) resp.
180 Mbps (1000-BASE-T interface).
The current needed data rate is shown on the left side in parentheses (e.g.
7.3 MBits). This indication is dropped at setting "auto".
• Use the
buttons to position the cursor under the digit of the data rate
displayed to be set.
• Using the
buttons set the desired data rate.
—>
Indication ">"
: Current needed data rate of this IP output is higher
than the data rate set (overflow).
Indication "!"
: The sum of all output data rates set is higher than
80/180 MBits.
• Press the
button.
Содержание HDE 400
Страница 1: ...Assembly Instruction HDE 400 ...