Page 4
Powering on and Programming
1. Connect the 12 volts dc into the power in plug (refer to page 8)
2. Switch on the unit by pressing the switch towards Position 1
3. The
red
LED will be illuminated solid while it searches for a signal, when the signal has
been found the LED will change from solid to flashing every 20 seconds. The unit is
now ready for use.
4. You can now programme your personal contact number into the alarm. This number
can be a mobile or landline telephone number.
5. You will need to send a SMS text message as folllows (please change the example
number for the number you want to use)
Ex a mp le : (
h a s h
) (1, 2 o r 3) (
e q u a ls
) (p h o n e n u mbe r) (
h a s h
)
#NUMB
=
01234567890
#
Then send this as a text to the simcard number in your unit
6. The unit will reply back with “number stored”
7. To change the number please send the text command
#
reset
#
The unit will reply back
with an acknowledgment “reset completed” you can then repeat steps above to add
a new number
Activating the Alarm
There are two ways to activate your alarm, using the keyfob or a text message.
Remote Fob Activation
Pressing a) will arm the alarm. The siren will beep twice to acknowledge the command.
Pressing b) will disarm the alarm. The siren will beep twice to acknowledge the command.
When the alarm has been triggered, pressing B will stop the siren from sounding. If you
disarm the alarm within 5 seconds of the alarm being trigger it will also stop the phone
alerts being sent - this is useful for false alarm situations.
Battery life on the key fob is approximately 2 - 3 years on a button battery
Text message activation
Sending the text message command
#
alarm
=
on
#
This will arm the alarm, you will receive the text message acknowledgment back Alarm=On
Sending the text message command
#
alarm
=
off
#
This will disarm the alarm, you will receive the text message acknowledgment back
Alarm=Off
