How to Programme the SMS
You can now change the alarm message for inputs 1 & 2 to your own choosing.
To change the message send the text command as follows.
NOTE
- Your message should read a message of your choosing up to 19 characters long.
#
MESS1
=
YOUR MESSAGE
#
The default message is (Input 1)
#
MESS2
=
YOUR MESSAGE
#
The default message is (Input 2)
This will change the message to ‘YOUR MESSAGE’
Telephone Call Alerts
The Auto Dialler can be programmed to send you a call after each text alarm has been
sent.
You will receive approximately three ring tones. The unit will then hang up automatically
avoiding any call charges being incurred.
To set call alerts to ON please send the text message
#
CALL
=
ON
#
The unit will reply back “CALL ON”
To disarm the call alerts please send the text message.
#
CALL
=
OFF
#
If the call function has been set to ON you will receive a text message and shortly after a
phone call.
How to Use the GSM Auto Dialler
The Auto Dialler has two inputs.
Input 1 = Terminal 1 Connection.
(Negatively Triggered) Pulled to Ground
Input 2 = Terminal 2 Connection.
(Negatively Triggered) Pulled to Ground
When the inputs are triggered the
GREEN
ready LED will flash 6 times to indicate that a
trigger has been received and it will send a text and/or call to the saved user numbers.
Both Input 1 and input 2 can be triggered independently.
The Auto Dialler will reset automatically when the triggered input is released.
Page 5
www.gsm-activate.co.uk
- 01273462380 - [email protected]
