Page 2 of 4
Model:
REC – 1240C
REC – 1260C
Unit 2, 110 Station Road, Seven Hills ,NSW, 2147, Australia
24V to 12V
Switchmode Battery Chargers
Operating Instructions
Please read these instructions before use
7.
Never smoke or light cigarettes near a battery.
8.
Do not place tools on top of battery or allow tools to fall on battery.
9.
Always wear eye protection near a charging battery.
10.
Ensure a “well” ventilated area is used when testing or re-charging batteries.
11.
Ensure ventilation is adequate and venting holes are not obstructed. Inadequate ventilation may over-heat the
12.
.
Seek medical attention if necessary.
REC-C-R2
If the unit is in one of the following conditions. reset as follows:
- Battery Reversal Protection
: If the unit is hooked up in reverse then simply reconnect the unit as per Fig.1
- Output Over Voltage:
If the output over voltage protection has been tripped then there will be no operation from
the unit. Contact supplier or GSL Electronics for Warranty Advice.
- Thermal Protection:
For your safety and for the longevity of your purchase, the unit will shut down to protect itself
and your batteries when the unit exceeds it nominal operating temperature. To reset this condition the unit must be
disconnected from the battery for at least one minute to allow cooling and for the microprocessor to reset.
Should product require service, return it to your place of purchase for Warranty Advice.
