Warranty Conditions:
The product is warranted to be free from defects in materials and workmanship under normal use and service
for a period of 24 months from the date of sale. This warranty covers defective parts and workmanship provided that the product
is shipped prepaid to the seller within 24 months of purchase of goods. This warranty is limited to the repair or replacement (at the
manufacturers’ discretion) of parts and shipping prepaid to the original despatch destination. We regret that no liability can be accepted
for consequential or special damages of any kind howsoever arising in connection with products supplied by the seller. This warranty
is in lieu of all other warranties expressed or implied. No representative is authorised to assume for the seller any other liability in
connection with the seller’s products.
Wiring: Please ensure that a fuse is
fi
tted in the Blue Wire (Brake).
The Brake Controller has four (4) coloured wires, black, red, blue and white. The black wire is the positive voltage power
supply line. The red brake wire powers up the electronic circuit of the unit and must be connected to the cold side of the brake
light switch. The blue brake wire must be connected directly to the trailer brake wire. The white ground wire is connected to a
grounded metal part of the dash,vehicle
fi
re wall or directly to the negative battery terminal.
Important:
A brake control unit that is not properly grounded may operate intermittently or not at all.
• Make sure all connections are secure.
• Do not connect the Black “BATTERY” wire to the fuse panel or tie into any accessory wiring.
Connecting to the existing wiring may damage the vehicles wiring and cause trailer brake failure.
• Do not reverse Black “BATTERY” wire and White “GROUND” connections.
Even a momentary incorrect connection can damage the brake control unit.
Unit 2, 1 St James Place, Seven Hills ,NSW, 2147, Australia
RBC-R1
Page 2 of 2
Installation & Operating Instructions
Please read these instructions before use
Models:
RBC-12 & RBC-24
12V and 24V
Remote Brake Controllers
Set-up & Operation :
Setting the braking force:
To set the brake intensity simply rotate the knob until the required
braking level is achieved. A clockwise knob rotation will increase
the braking and a counterclockwise will decrease it.
Setting the Ramp-up Feature:
To activate the Over-Ride function simply push on the adjustment knob,
releasing the knob disables the function. The braking force when the
Over-Ride is active is still determined is still determined by the knob position.
LED INDICATION
LED OFF
Trailer brakes disconnected or no input
power to the unit
LED ON
Trailer brakes connected
LED Flashing
Brakes on at the selected level, either via
brake pedal or Over-Ride function
* Please Note: An External Fuse Must Be Fitted (Not Supplied).
WIRING INSTRUCTIONS
White Wire
0V DC
Blue Wire
Brake
15A Fuse*
Black Wire
+VDC
Red Wire
Brake Switch
lied).
* The Control Unit is Activated by A Positive Feed Brake Switch Only.
(Please check the polarity of your vehicles brake switch before connection)
More information https://www.caravansplus.com.au
