GSi TopDry Autoflow, Руководство по монтажу

Страница: 129 / 142

11
Accessories
Topics Covered in this Chapter
▪ Assembling the TopDry Access Door
▪ Assembling the Access Door Platform
▪ Assembling the Cross Over Platform
▪ Door Placement
▪ Two Ring Door Installation Instructions
Assembling the TopDry Access Door
Follow the instructions to assemble the TopDry access door.
1. Install the top and bottom Z-frames (B) to the inside of the access door plate (A) using 5/16 x 3/4 in.
flange bolts (F) and 5/16 in. flange nuts (G).
NOTE: The first set of Z-frames (B and C) comes pre-assembled to the access door plate (A).
2. Install the side Z-frames (C) to the inside of the access door plate (A) using 5/16 x 3/4 in. flange
bolts (F) and 5/16 in. flange nuts (G).
3. Attach the top and bottom rear door catches (H) to the back of the Z-frames (B). Refer to the layout
and position the rear door catches (H) with the left most hole aligned with the center hole of the
access door plate (A).
4. Center the doors over the opening and attach the top access door (D) and inside access door (E) to
the Z-frames (B) using 5/16 x 3/4 in. flange bolts (F) and 5/16 in. flange nuts (G)
5. Secure the 5/16 x 3/4 in. flange bolts (F) to the doors with the 5/16 in. flat washers (I) and 5/16 in.
lock nuts (J).
NOTE: Do not overly tighten the lock nuts (J). This will allow the doors to move freely.
6. Attach the handles (K and L) to the access doors (D and E) using handle gasket (S), #10 x 5/8 in.
screws (M) and #10 hex nuts (N).
NOTE: The locking handles along with the hardware labeled “out”, go to the outside doors. The rear
handles have their own hardware package.
7. Attach the front door latches (O) to the front door handles (K) using 5/16 x 3/4 in. flange bolts (Q)
and 5/16 in. hex nuts (R). Adjust the front door latches (O) to catch the inside lip of the front
Z-frames (B).
8. Attach the rear door latches (P) to the rear door handles (L) using 5/16 x 3/4 in. flange bolts (Q) and
5/16 in. hex nuts (R). Adjust rear latches (P) to fit the slot in the top and bottom catches (H) attached
to the rear Z-frames (B).
9. Attach the assembled access door to the access door panel.
PNEG-4936 36 Ft. TopDry Autoflow 129