1. Safety
6
PNEG-1724
S2 Quick Start Guide Canister
Install and Operate Electrical Equipment Properly
Electrical controls should be installed by a qualified electrician
and must meet the standards set by the National Electrical Code
and all local and state codes.
Disconnect and lock out all power sources before installing
wires/cables or servicing equipment.
ELECTRICAL WARNINGS
A. Install and ground the slip ring and the entire unit in accordance with the National Electric Code
and local codes and/or ordinances.
B. DANGER: Hazard of electrical shock or burn. Always disconnect the power from the collector ring
before attempting to perform any service function. Follow lock out/tag out procedures as outlined
in O.S.H.A., section 1910.147 where appropriate.
C. Do not use this slip ring with electrical loads greater than the rated current and voltage.
D. Information regarding the current and voltage rating of each slip ring is recorded on a tag
permanently fastened to the ring assembly.
E. 1 R-Series Slip Rings withstand a maximum ambient temperature of 220°F.
F. The model number of the slip ring assembly indicates the ampacity and voltage rating of each
type of ring and brush included on the assembly.
NOTE:
The actual ampacity may be affected
by the type and size of the core lead wire (refer to NEC Table 310-16, 17, 18, 19 and
applicable notes).
Electric Shock Hazard
Prepare for Emergencies
Be prepared if fire starts.
Keep a first aid kit and fire extinguisher handy.
Keep emergency numbers for doctors, ambulance service,
hospital and fire department near your telephone.
Keep Emergency Equipment
Quickly Accessible
