GSi GCE 45, Инструкция по установке и эксплуатации

Страница: 29 / 46

7. Wiring Diagrams
PNEG-2175CE CE Compliant Sampler - Model GCE 45 and GCE 90 29
CE Control Electrical Layout (Continued)
1. The control requires a 400 Volt, 3 PH and neutral supply (TPN) with minimum current capacity of
10 Amp.
2. Run suitable type cables to the components on the Sampler and Divider as indicated in the
Figure 7A on Page 28
.
NOTE:
The conductor cross section areas stated above the minimum and should be increased if
required, according to local regulations, length of cable and voltage drop.
3. When making connections to the sampler and divider components, refer to the certified drawing
provided with your controls (See
Figure 7B on Page 30
,
Figure 7C on Page 31
and
Table below
).
Electrical Connections
Item Voltage Maximum Current Terminal (Block) Numbers
Power Supply (TPN) 400 VAC 10 Amp (X1) 1, 2, 3, N, PE
Service Disconnect Switch 400 VAC 10 Amp (X1) 4, 5, 6, 7, 8, 9, PE
Sampler Motor 400 VAC 7 Amp (X2) 1, 2, 3, PE
Divider Motor 400 VAC 1 Amp (X2) 4, 5, 6, PE
Sampler Motor Thermal Protection 24 VDC 1 Amp (X3) 1, 2
Divider Motor Thermal Protection 24 VDC 1 Amp (X3) 3, 4
Right Limit Switch 24 VDC 1 Amp (X3) 5 (COM), 6 (N.C.), 11 (N.O.), PE
Left Limit Switch 24 VDC 1 Amp (X3) 7 (COM), 8 (N.C.), 12 (N.O.), PE
External Emergency Stop 24 VDC 1 Amp (X3) 9, 10, PE