GSi Agri-Alert 128 Touch, Руководство по установке и настройке

Страница: 83 / 120

12
Configuring an Intrusion Zone
Topics Covered in this Chapter
▪ Naming the Zone with a Text Label
▪ Selecting a Module
▪ Selecting an Input
▪ Selecting a Zone Type
▪ Choosing the Type of End of Line Resistor
▪ Selecting the Type of Contact in the Dry Contact Zone
▪ Providing Enough Time to Disarm After Entry
▪ Providing Enough Time to Exit After Arming
▪ Activating the at Home Arming
▪ Activating the Chime on an Intrusion Zone Type
▪ Activating a device in the Event of an Alert or Trouble
▪ Receiving a Phone Call When an Alert is Active
▪ Receiving an E-mail When an Alert is Active
▪ Enabling the Siren
▪ Enabling the Internal Speaker
▪ Recording the Zone Audio Label
▪ Viewing Zone Calibration
Naming the Zone with a Text Label
The zone text label is a name you give to a zone to facilitate its identification. In addition to the zone
number, the text label appears everywhere where the zone is identified in writing on the user interface.
1. In edit mode, under the General tab of the zone you are configuring, click on the edit field next to the
Name button.
2. Type in the zone label of your choice.
NOTE: The field is limited to XX characters.
Selecting a Module
By selecting a module you link the zone to the area you want to monitor.
1. In edit mode, under the General tab, click on the Module edit field to display the selection box.
2. Select a module from the list.
NOTE: Only the modules that are connected to the system and that are initialized in the system are
available for selection.
895–00677 Agri Alert 128 Touch 83