GSi 21' Diameter Gamma, Руководство по сборке

Страница: 18 / 38

4. Roof Assembly
18 PNEG-2145 21' Diameter Gamma Roof Assembly Instructions
Installing the Eave Clip and Intermediate Eave Angle to the
Sidewall Sheet
The eave clips and intermediate eave angles are installed onto the sidewall sheet to assemble the
roof panels.
1. Install the eave clips (B or F) to the sidewall sheet (E) with flange bolts (C) and flange nuts (D).
NOTE: Make sure to install the eave clips (B or F) to the inside of the sidewall sheet (E).
2. Install the intermediate eave angle (A) to the sidewall sheet (E) with flange bolts (C) and flange
nuts (D) between the two (2) eave clips (B or F).
NOTE: Make sure to install the intermediate eave angle (A) to the outside of the sidewall sheet (E)
for 4.00" bins. (See Figure 4D.)
NOTE: Make sure to install the intermediate eave angle (A) to the inside of the sidewall sheet (E)
for 2.66" bins. (See Figure 4E on Page 19.)
3. Repeat the process to continue installing the remaining eave clips (B or F) and intermediate eave
angles (A).
4. Tighten the hardware to the recommended torque specifications. See bolt torque specifications
on Page 14.
Figure 4D Installing the Eave Clip and Intermediate Eave Angle to the Sidewall Sheet for 4.00"
Ref # Part # Description Ref # Part # Description
A CTR-1183 Intermediate Eave Angle D S-3611 5/16" Flange Nut
B CTR-1201 Eave Clip E Sidewall Sheet
C S-10260 5/16" x 1" Flange Bolt