GSI Group PNEG-1451, Руководство по установке

Страница: 47 / 118

6. 2.66" Corrugated Commercial Hopper Tank 10-22 Rings
PNEG-1451 Ladder, Safety Cage and Platform for Hopper Tanks 47
Eave Starter Bracket and Ladder Assembly with Safety Cage
Once the two (2) 3/8" holes have been field drilled, attach the starter brackets (D) to the sidewall as shown
in
Figure 6D . Check the top ladder section (F) to make sure the ladder rung dimples are to the top. Attach
starter brackets (D) to the top of the ladder. It will be necessary to field drill a 3/8" hole (C) in the ladder
section (F) for the starter bracket (D) as well.
(See Figure 6F on Page 49.) See Figure 4B on Page 13 for
the proper installation of additional ladder sections (F) required. Standoff brackets (E) must be installed
on the ladder sections (F) and attached to the sidewall at each horizontal seam and repeated every 32".
Use 5/16" x 3/4" bin bolts for all connections.
Figure 6D
NOTE: Refer to Figure 4A on Page 12 for additional details for standoff bracket to ladder assembly and
8' extension rail installation (omitted in detailed image above for clarity).
Ref # Description
A Additional nuts required to support starter bracket and standoff brackets.
B 32" Typical
C Field Drill 3/8" Hole for Starter Bracket
D Starter Bracket (LDR-4346 L.H. and LDR-4347 R.H.)
E Standoff Bracket (LDR-4314)
F 4' Ladder Section