9. Assembly
70
PNEG-1276
Top Dry Autoflow Construction Manual 24', 30' and 36'
Top Dry Access Door Assembly (TD-100996)
1. Assemble the Z-frames (TD-100991 and TD-100992) and then attach the frames (TD-100991 and
TD-100992), to the inside of the access door plate (TD-100990).
NOTE: The first set of Z-frames
comes pre-assembled to the access door plate.
2. Now attach the top and bottom rear door catches (TD-101020) to the back of the Z-frames. Referring
to the layout, position the catches with the left hand most hole aligned with the center hole of the
access door plate.
3. Using washers to center the doors over the opening, attach the top access door (TD-100993) and
the inside access door (TD-100994) to the Z-frames. Utilize the lock washers to secure the bolts to
the doors. Do
not
overly tighten the lock washers. This allows the doors to move freely.
4. Now attach the handles (D02-0045 and D03-0512) to the doors.
NOTE:
The locking handles
along with the hardware labeled “out”, go to the outside doors. The rear handles have their own
hardware package.
5. With the nut and bolt supplied, attach the appropriate latches to the handles and lock them.
.) Adjust front latches (TD-101021) to catch the inside lip of the front Z-frames. Adjust
rear latches (TD-101022) to fit the slot in the top and bottom catches attached to the rear Z-frames.
6. Attach the assembled access door to the access door panel (TD-101025).
Figure 9X
Ref #
Part #
Description
Qty
1
TD-100990
Access Door Plate
1
2
TD-100991
Access Top/Bottom Z-Frames
4
3
TD-100992
Access Door Side Z-Frames
4
4
TD-100993
Top Access Door
2
5
TD-100994
Inside Access Door
2
x
TD-101020
Rear Door Catches
2
x
TD-101021
Outside Door Latches
2
x
TD-101022
Inside Door Latches
2
x
D03-0512
Lockable Handle
2
x
D02-0045
Gasket for Lockable Handle
2
x
ACD-4513
Access Door Handle w/ Gasket
2
