UDS-KPM-094-01B-2
8
(1)
Positive Battery Terminal
The terminal for connecting the external cable. When attached, ensure the distribution cable
is in full contact with the battery terminal and is secured with the enclosed M8 (opposite
side: 12). The thickness of the connectable cable should be 60 mm
2
or less. In lieu of a
cable, a copper bar may be used to connect to the battery terminal. The copper bar
maximum dimensions are 20 to 25 mm Width × 2 to 4 mm Thickness.
(2)
Negative Battery Terminal
The negative battery terminal uses the same design as that of the positive battery terminal.
The positive terminal is provided at the right, and the negative terminal is at the left.
(3)
Terminal Protection Cover
The cover protecting the positive and negative battery terminals. Note that the exposed
terminals are danger. After wiring, make sure to install terminal protection covers.
(4)
Battery Monitor Board (Built-In)
An electrical terminal for monitoring the battery voltage or module temperature as well as
equalizing the battery voltage.
(5)
Communication Connector
A communication connector with LIBM.
CN1: Communication Receiver, CN2: Communication Transmitter
(6)
Fixing Parts at Front
Use bolts (M8) at the two cutout parts to fix the battery module.
(7)
Fixing Parts at Rear
Use bolts (M8) at the two cutout parts to fix the battery module.
(8)
Handle
A handle to take out the battery module from the battery rack.
(9)
Grip Part at Rear
A grip part at the rear side of the module. When carrying the battery module, be sure to hold
this part.