22
Operating instructions
GS 0850
GS Engineering B.V.
manufacturer hydraulic sweepers
When the height of the brush is adjusted in such a way that it
sweeps the sweeping surface extending over a bigger length, it
could result in increased brush wear. This shortens the brush's
life.
3.3.4 Angle adjustment of the brush
The brush can be placed in an angled position in relation to the direction of
movement. To place the brush in an angled position or release the brush from its
angled position, lift the pin and turn the brush. (see Illustration 1)
Illustration 1
Illustration 2
Lower the pin after that (see Illustration 2).
If the pin does not lower completely, turn the brush slightly until the pin lowers.
The angle of the brush can only be adjusted when the engine
is not running.
3.4 Driving
The machine has its own hydraulic drive. This enables it to make forward and
backward movements.
To move, it is necessary to keep the appropriate movement handle in a certain
position; the control device is the handle located on top of the pushing bar. When the
handle is released, the machine will stop moving immediately. An illustration has
been affixed to the push bar of the machine as shown on the following illustrations.
